JGM dog door flap replacement kit with clear vinyl flap, magnets, weatherstripping and tunnel carpet rolls, with the text Fresh flaps, fresh seal

How to Replace the Flap on a JGM Pet Door

Quick answer: To replace the flap on a JGM pet door, remove the screws holding the old flap, pry out the old magnets and weatherstripping, tap in the new ones, then center the new flap and screw it back in. It's a short DIY job with basic tools. Here's exactly how to do it.

JGM dog door flap replacement kit with a clear vinyl flap, weatherstripping, magnets, and beige and gray tunnel carpet

A JGM Flap Kit: flap(s), weatherstripping, magnets and tunnel carpet

Flaps
From $35
Full flap kits
From $70
Fits
JGM pet doors only

Signs it's time for new flaps

  • You can see daylight around the edges of the flap.
  • You feel a draft, or bugs and dust are getting in.
  • The flap is cracked, warped or stiff.
  • The flap doesn't close flat, or the magnets don't hold it shut.

Getting ready for winter? See our cold-weather dog door guide for a full winterizing checklist.

Flap or flap kit?

Replacement Flaps · from $35
The flap only, made from extreme-temperature PVC vinyl. Order the interior flap, the exterior flap, or both. Shop flaps
Flap Kits · from $70
A full refresh: flaps, self-tapping screws, weatherstripping and magnets, plus replacement tunnel carpet for Wall Models. Shop flap kits

If your flap still seals but is scratched or cracked, a new flap may be all you need. If you're feeling drafts or the flap won't stay shut, get the kit so the magnets and weatherstripping are fresh too.

Find your size

Measure only the clear flap opening, not the aluminum frame: width (side to side) by height (top to bottom). Then match it to a size below. Order the model that matches your door: Door Model if it's mounted in a door, Wall Model if it goes through a wall.

Small
7" x 11"
Medium
9" x 13"
Extended Medium
9" x 17"
Large
11" x 17"
Extended Large
11" x 21"
Super Extended Large
11" x 25"
Extra Large
14" x 21"
Extended Extra Large
14" x 25"
Jumbo
16" x 30"

Not sure? Call us at (602) 738-3667 before you order. Replacement parts fit JGM pet doors only.

What you'll need

✓ Long Phillips screwdriver, or a drill with a bit holder extension and #2 Phillips bit (recommended)
✓ Flat screwdriver or chisel (a chisel is recommended)
✓ Rubber mallet or hammer (a rubber mallet is recommended)
✓ Adjustable bar clamp
✓ Caulk gun, for Wall Model carpet
✓ Latex painter's caulk, for Wall Model carpet
Before you start: check that your new parts are the right size for your door. Compare the flap size, where the metal strikes sit on the flap, and the number and length of the weatherstripping pieces and magnets. Laying the new weatherstripping beside the new flap makes it easy to see that everything is there. If anything looks wrong, call us at (602) 738-3667.

Step-by-step: replacing your flaps

1

Remove the old flap

The screws holding the flap are reached from inside the pet door. Remove them, then pull down firmly on the flap. It should come loose from the frame.

Door Model only: a pet door in a standard door has to be taken apart to reach the flap screws. The screws holding the two halves together are in the groove between the two frames. Remove them and the outside frame comes off. The inside frame stays attached to the door with double-sided tape, so you can leave it in place while you work.
2

Remove the old magnets

Pry the magnets out of the frame with a flat screwdriver or chisel.

Good to know: the metal half-circles on the flap are not magnets. They're called strikes, and they touch the magnets in the frame to seal the flap.
Close-up of a JGM-stamped metal strike that attaches to the dog door flap
3

Remove the old weatherstripping

Slide the Phillips screwdriver under each piece of weatherstripping and pry it out of the channel.

4

Install the new weatherstripping and magnets

Put the new weatherstripping and magnets into the channel. Tap them into place with the mallet until they're no longer sticking out of the channel.

5

Insert the new flap

Set the new flap into the frame and center it. Use the flat screwdriver at the top of the flap to nudge it left or right until it's centered. Check that it swings freely while you hold it in place.

6

Screw the flap in place

Hold the flap steady with the flat screwdriver or chisel so it can't shift. Drive the screws back into the same holes they came out of, using the drill and a #2 Phillips bit. A long bar clamp makes this easier: use it to press the flap's top bar into the flap channel while you drive the screws.

7

Adjust the magnets

Tap the magnets in or pry them out as needed with the flat screwdriver or chisel. When the flap is closed, there should be no visible gap between each magnet and its strike.

8

Clean the flaps

Soapy water and a Magic Eraser-type sponge keep the flaps clean. If you took apart a Door Model, put the outside frame back on with its screws.

9

Replace the tunnel carpet (Wall Model only)

The new carpet comes cut to length. Measure the width of the tunnel in the wall and cut the new piece to that size or you can match it to the existing carpet's width. Latex painter's caulk works well as the adhesive.

Common mistakes to avoid

✕  Measuring the frame instead of the flap opening. Measure only the clear opening your pet walks through.

✕  Ordering for a different brand. JGM flaps and parts fit JGM pet doors only.

✕  Prying at the strikes. The metal half-circles on the flap are strikes, not magnets. The magnets are in the frame.

✕  Leaving magnets sticking out of the channel. Tap them in until they sit flush.

✕  Screwing in an off-center flap. Center it and check that it swings freely before driving the screws.

✕  Skipping the magnet adjustment. Any gap between a magnet and its strike lets drafts in.

Frequently asked questions

Will JGM replacement flaps fit my pet door?

Only if you have a JGM pet door. Our flaps and parts are made for JGM doors and won't fit other brands.

Can I replace just one flap?

Yes. Replacement Flaps come as the interior flap, the exterior flap, or both.

What comes in a flap kit?

Flaps, self-tapping screws, weatherstripping and magnets. Wall Model kits also include replacement tunnel carpet in beige or gray.

How do I clean my pet door flaps?

Soapy water and a Magic Eraser-type sponge do an excellent job.

What if my parts don't look right?

Compare them to your old flap before you start. If anything looks off, call us at (602) 738-3667 and we'll help.

Give your pet door a fresh seal

Genuine JGM replacement parts, made to fit your JGM pet door.

Shop Flap Kits Shop Replacement Flaps

Not sure of your size? Call (602) 738-3667, Monday through Saturday, 8am to 5pm Arizona time.

Back to blog