How to Install a Dog Door in a Door
Share
Quick answer: Installing a dog door in a door is the simplest pet door install. Trace the template, cut the opening with a jigsaw (or a reciprocating saw for metal doors), stick the inside frame in place, screw the outside frame to it, and seal the outside. No tunnel is needed.
A JGM Large door mount dog door in an exterior front door
The JGM Door Model fits interior and exterior doors 1.75" to 2" thick, solid-core or hollow-core, including wood, fiberglass and steel doors. Every door comes with a full-size template, screws and instructions, and ships anywhere in the U.S.
What you'll need
Your JGM Door Model comes with the template, the inside and outside frames, and screws. You'll also need:
Before you order
Measure the door's thickness. The Door Model fits doors 1.75" to 2" thick. If yours is thinner, contact us before ordering.
Measure your dog standing up: floor to top of shoulders plus 1 to 2 inches, and the widest part of the body plus 1 to 2 inches. See our sizing guide.
Step-by-step installation
Prepare the work area
Lay drop cloths where you'll be working and put on safety glasses and any other safety gear you need.
Mark the door
Measure and mark the height you want the pet door at. Place the template on the door, level it, and trace the outline with a pencil.
Cut the opening
Cut along the outline with the right tool for your door: a jigsaw for wood doors, or a reciprocating saw for metal doors.
Test fit
Set the pet door in the opening and make sure it fits properly. Then take it back out before going on.
Attach the inside frame
Peel the backing from the adhesive tape on the inside frame. Level the frame and press it into position on the door.
Attach the outside frame
Insert the outside frame's flange into the inside frame's flange. Fasten the two frames together through the pilot holes with the supplied screws.
Seal the outside
On an exterior door, apply exterior-grade sealant around the outside frame to create a weather-tight seal.
Finish up
Clean the flap and frame, and adjust the magnets so there's no gap between each magnet and the metal strike on the flap. Then clean up the work area.
Common mistakes to avoid
✕ Skipping the level. Level the template before tracing and the inside frame before pressing it on.
✕ Using the wrong saw. A jigsaw for wood, a reciprocating saw for metal.
✕ Skipping the test fit. Check the opening before the adhesive frame goes on.
✕ Ordering for a door that's too thin. The Door Model fits doors 1.75" to 2" thick.
✕ Leaving gaps at the magnets. Adjust them until each one touches its strike.
✕ Skipping the sealant on an exterior door. It's what keeps rain and drafts out.
Frequently asked questions
Does a door mount dog door need a tunnel?
No. The Door Model is designed for doors 1.75" to 2" thick, so the inside and outside frames screw together through the door without a tunnel.
Can I put a dog door in a steel or fiberglass door?
Yes. The Door Model works in wood, fiberglass and steel doors. Use a reciprocating saw for metal doors.
Can I put it in a glass door?
No, the Door Model is for solid doors. For sliding glass doors, see our sliding glass guide.
Is a door or wall install better?
A door install is simpler and costs less. A wall install keeps your doors intact and lets you choose the spot. Compare them in our wall vs. door vs. sliding glass guide.
Can you install it for me?
Yes. In the Phoenix and Tucson areas, our team offers professional installation. Call (602) 738-3667 for a free quote.
Ready to get started?
Dual insulated flaps, a magnetic seal and a locking security cover, built in Phoenix since 2009.
Shop the Door Model Call (602) 738-3667Not sure which size? We're here Monday through Saturday, 8am to 5pm Arizona time.